HUAWEI AP2030DN Gigabit 802.11ac in-wall 200m WIFI Access Point

Supports 2.4 GHz and 5 GHz frequency bands, with ports for wired, wireless, and phone line connections. Wall-mounted, gigabit 802.11ac Access Points (APs) in a sleek design with built-in antennas, indicator lights hidden behind a sliding panel.


HUAWEI AP2030DN Gigabit 802.11ac in-wall 200m WIFI Access Point


Product appearance

  1. ETH0 to 3: 10M/100M port connects to the wired Ethernet
  2. Phone: Phone port used to connect to the phone or ADSL device through phone lines
  3. GE/PoE: 10M/100M/1,000M port used to connect to the wired Ethernet. The port can also connect to a PoE power supply
  4. Phone: Phone port connects to the server through phone lines
  5. Default: Hold down the button more than 3 seconds to reset factory settings 
  6. Power input interface: 12V DC




Dimensions (H x W x D)

1.6 in. x 3.3 in. x 5.5 in. (41.5 mm x 86 mm x 140 mm)


0.5 lb. (0.23 kg)

System memory

· 128 MB DDR2

· 32 MB Flash


Power input

· DC: 12 ±10%

· PoE: in compliance with IEEE 802.3af/at

Maximum power consumption


Note: Actual maximum power consumption depends on local laws and regulations


Operating temperature and altitude

· 32oF to 104oF (0oC to 40oC)

· -196.8 ft. to 16,404.1 ft. (-60m to 5,000m)

Storage temperature

-40oF to 158oF (-40oC to 70oC)

Operating humidity

5% to 95% (Non-condensing)

Ingress protection rating


Atmospheric pressure

20.6 inHg to 31.3 inHg (70 kPa to 106 kPa)



Antenna Type


Antenna Gain

· 2.4 GHz: 2 dBi

· 5 GHz: 3 dBi

Maximum Number of Users

≤ 64

Maximum Transmit Power

· 2.4 GHz: 21 dBm (Combined power)

· 5 GHz: 20 dBm (Combined power)

Note: You can adjust the transmit power from maximum transmit power to 21 dBm, 1 dB at a time. Actual transmit power depends on local laws and regulations. The AP2030DN uses a 86-type box and applies only to countries and regions that support 86-type boxes

Maximum Number of Non-overlapping Channels

2.4 GHz

 -20 MHz: 3

 -20 MHz: 3
 -40 MHz: 1

5 GHz

-20 MHz: 24

-20 MHz: 24
-40 MHz: 11


 -20 MHz: 24
 -40 MHz: 11
-40 MHz: 5

Note: The table uses the number of non-overlapping channels supported by China as an example. The number of non-overlapping channels varies in different countries. For details, see the Country Code and Channels compliance status

Typical Fit AP networking

Product characteristics


· IEEE 802.11a/b/g/n/ac compliant

· Maximum rate of 1.167 Gbit/s

· Maximum Ratio Combining (MRC)

· Space Time Block Code (STBC)

· 802.11n Beamforming

· Low-Density Parity-Check (LDPC)

· Maximum-Likelihood Detection (MLD)

· Data unit aggregation, including A-MPDU (Tx/Rx) and A-MSDU (Rx only)

· 802.11 Dynamic Frequency Selection (DFS)

· Cyclic Shift Diversity (CSD)

· Short GI in 20 MHz and 40 MHz modes

· Priority mapping and packet scheduling based on a Wi-Fi Multimedia (WMM) profile to implement priority-based data processing and forwarding

· Automatic and manual rate adjustment

· WLAN channel management and channel rate adjustment

· Automatic channel scanning and interference avoidance

· Service Set Identifier (SSID) hiding, support for SSIDs in Chinese

· Automatic SSID hiding: An AP automatically hides its SSIDs when the number of access terminals reaches the maximum

· Signal Sustain Technology (SST)

· Unscheduled Automatic Power Save Delivery (U-APSD)

· Control and Provisioning of Wireless Access Points (CAPWAP)

· Automatic login

· Extended Service Set (ESS)

· Multi-user CAC

· Hotspot 2.0

· 802.11k and 802.11v smart roaming


· IEEE 802.3u and IEEE 802.1q compliant

· Rate and duplex mode auto-negotiation and automatic switchover between the Media Dependent Interface (MDI) and Media Dependent Interface Crossover (MDI-X)

· SSID-based VLAN assignment

· 4,094 VLAN IDs (1 to 4,094) and a maximum of 8 Virtual APs (VAPs) for each radio frequency

· AP control channel in tagged and untagged mode

· DHCP client obtains IP addresses through DHCP

· Tunnel and direct data forwarding

· STA isolation in the same VLAN

· Multicast Domain Name Service (mDNS) gateway protocol: supports AirPlay and AirPrint service sharing between users of different VLANs

· Access Control Lists (ACLs)

· Link Layer Discovery Protocol (LLDP)

· Uninterrupted service forwarding upon CAPWAP channel disconnection

· Unified authentication on the AC

· AC dual-link backup


· IPv6 in Fit AP mode

· Soft GRE



· Open system authentication

· WEP authentication/encryption using a 64-bit, 128-bit, or 152-bit encryption key

· WPA/WPA2-PSK authentication and encryption (WPA/WPA2 personal edition)

· WPA/WPA2-802.1x authentication and encryption (WPA/WPA2 enterprise edition)

· WPA-WPA2 hybrid authentication

· WAPI authentication and encryption

· Supports Wireless Intrusion Detection System (WIDS) and Wireless  Intrusion Prevention System (WIPS), including rogue device detection and countermeasure, attack detection and dynamic blacklist, and STA/AP blacklist and whitelist

· 802.1x authentication, MAC address authentication, and portal authentication

· DHCP snooping

· Dynamic ARP Inspection (DAI)

· IP Source Guard (IPSG)

· 802.11w Protected Management Frames (PMFs)